If you do not use an HP ceiling mount, mount the projector according to the following
X = 176 mm (6.93 in.)
Y = 188 mm 7.40 in.)
Z = 86 mm (3.39 in.)
Thread size = M6
To install for rear projection
1. Place the projector 1.5 to 14 m (5 to 46 ft) behind a translucent screen that is
designed for rear projection.
See "To install on a table" on page 18 or "To install on the ceiling" on page 18 for
2. Open the on-screen menu and select setup > Projector position. Then select
Rear Table or Rear Ceiling from the drop-down list.
If the projector is not visible to the remote control, you can use one of two techniques
to enable them to communicate. See "To connect control equipment" on page 33.
Installation and Setup