To set up network access
1. Plug a CAT5 network cable into the RJ-45 network port on the back of the
If the projector has power, the left indicator light on the network port turns on
showing a 10- or 100-Mb/s connection. The light on the right shows network
The projector normally attempts to get an IP address from a Dynamic Host
Configuration Protocol (DCHP) server, or, if a server is not available, it takes a
default address. The IP address is displayed at the bottom of the on-screen menu.
2. If you want to view or change the projector's TCP/IP network configuration,
turn on the projector, open the on-screen menu, select setup > Network, and
enter changes. If you are not running on a DHCP server, talk to your network
administrator to find the correct TCP/IP network settings.
To set the advanced network configuration, see "To set basic projector properties"
on page 54.
Installation and Setup