Monitoring A Stored Channels - GRE PSR-282 Owner's Manual

Notes:
• To reverse the scanning direction, press
• To set the scanner to remain on the current channel
for 2 seconds after the transmission ends, see "De-
lay" on Page 19.
• To set the scanner to remain on the current channel,
even after the transmission stops, press SCAN/MAN
at any time during the transmission. MAN appears and
SCAN disappears (see "Monitoring a Stored Chan-
nel").
• To lock out channels so the scanner does not stop for
a transmission on those channels, see "Locking Out
Channels or Frequencies" on Page 19.
Turning Channel-Storage Banks Off and
On
Channel-storage banks (1-10) are on when they have a
bar underneath them and off when no bar appears un-
derneath them. To turn off a channel-storage bank, press
the bank's number key during scanning. The bar under
the bank's number disappears.
To turn on a channel-storage bank (1-10) during scan-
ning, press the bank's number key. A bar appears under
the bank's number.
Note: The scanner does not scan any of the channels
within the banks you have turned off.
You cannot turn off all banks. There must be at least one
active bank.
You can manually select any channel in a bank, even if
the bank is turned off.
When you turn on a bank during scanning, the scanner
moves to the selected bank and scans it.
If no transmission is found, the scanner continues to scan
through all selected banks.
Monitoring a Stored Channel
You can continuously monitor a specific channel without
scanning. This is useful if you hear a transmission on a
channel and do not want to miss any details—even though
there might be periods of silence—or if you simply want
to monitor that channel.
Page 17
or .
17
2003/03/11, 15:46