Scanning The Stored Channels; Turning Channel-Storage Banks Off And On - GRE PSR-100 Owner's Manual

SCANNING THE STORED CHANNELS

To set the scanner to continuously scan through all channels with stored fre-
quencies, simply pressing SCAN until SCAN and
begins to rapidly scan until it finds an active frequency.
If the scanner finds an active frequency, it stops and displays that channel and
frequency number, then it automatically begins scanning again when the trans-
mission on that frequency ends.
Notes:
• To reverse the scanning direction, press
• To set the scanner to remain on the current channel for 2 seconds after the
transmission ends, see "Delay" on Page 25.
• To set the scanner to remain on the current channel, even after the trans-
mission stops, press SCAN/MAN at any time during the transmission so
MAN appears and SCAN disappears (see "Monitoring a Stored Channel").
• To lock out channels so the scanner does not stop for a transmission on
those channels, see "Locking Out Channels or Frequencies" on Page 25.

TURNING CHANNEL-STORAGE BANKS OFF AND ON

Channel-storage banks (1–10) are on when they have a bar underneath them
and off when no bar appears underneath them. To turn off a channel-storage
bank, press the bank's number key during scanning. The bar under the bank's
number disappears.
Note: The scanner does not scan any of the channels within the banks you
have turned off.
To turn on a channel-storage bank (1–10) during scanning, press the bank's
number key. A bar appears under the bank's number.
Notes:
• You cannot turn off all banks. There must be at least one active bank.
• You can manually select any channel in a bank, even if the bank is turned
off.
• When you turn on a bank during scanning, the scanner moves to the se-
lected bank and scans it.
If no transmission is found, the scanner continues scanning to scan through all
selected banks.
20
appear, then the scanner
or .