Using Tune - GRE PSR-282 Owner's Manual

Once you find interesting frequencies during the search,
you can store them into the scanner's channel-storage
banks.
1. To store the displayed frequency in the lowest avail-
able channel, press ENT when you find a frequency.
The channel number flashes.
2. Press ENT again to store the frequency. The channel
and frequency flash twice. If you want to cancel the
operation, press TUNE/CLR instead of ENT.
Note: If you entered a frequency that is already stored in
another channel, –dUPL– (duplicate) and the lowest-num-
bered channel containing the duplicate frequency flash
for about 3 seconds. If you want to store the frequency
anyway, press ENT again. You can then delete the fre-
quency later. See "Clearing a Stored Channel" on Page
18.
If there is no empty channel, Ch–FULL appears after you
press ENT. To store more frequencies, you must clear
some channels. See "Clearing a Stored Channel" on Page
18. To continue searching after Ch–FULL appears, press
TUNE/CLR.

Using Tune

You can set the scanner to search through all receivable
frequencies from a specified frequency. You can use the
scanner's delay feature while using tune.
Notes:
To reverse the tuning direction at any time, hold down
or for about 1 second.
To tune up or down the selected band in small incre-
ments (5, 8.333 or 12.5 kHz steps), repeatedly press
o r .
1. Repeatedly press SCAN/MAN until MAN appears.
2. Enter the desired channel number you want to use as
a starting point for the tune. Then press SCAN/MAN
again.
3. Press TUNE/CLR to start tune. –t– appears.
4. Hold down or
or down. or appear and the scanner searches
the frequencies.
Page 15
for about 1 second to tune up
2003/03/11, 15:46
15