Care & Maintenance; Assembly Instructions - York Fitness 56018 Owner's Manual

Assembly instructions

Care & Maintenance
• This equipment should not be placed outdoors, in a garage or an outbuilding. Keep the
equipment in a dry place with as little temperature variation as possible.
• We recommend placing a mat beneath the equipment to protect both the equipment and
your flooring.
• Always place the equipment in a dry environment.
• Use a warm, damp cloth to keep the product clean.
• No wet cleaning of electrical components. Unplug before any care and maintenance.
• The safety level of the equipment can be maintained only if it is regularly examined for
damage and wear. This includes any ropes, pulleys, nuts, bolts, moving parts, bushes,
chains, wheels, bearings & connection points etc.
• Ensure that you inspect the product regularly - at least once a week is recommended.
• Ensure that all fixings are tight before use.
• Always replace damaged / worn components with original parts from the manufacturer.
PREPARE YOUR WORK AREA - It is important you assemble the product in a clean and uncluttered space.
WORK WITH A FRIEND - We recommend you have someone assist you with the assembly as some of the
components are quite heavy.
OPEN THE CARTON - Check any warnings on the carton and make sure you have it the right way up.
UNPACK THE CARTON - Remove all the parts and lay them out on the floor.
Make sure you have the following parts:
15 x 4
Carriage
(M10 x 88MM) (ID10.5 x OD23 x T1.5mm)
25 x 1
Nyloc Nut Round Plastic Bolt Cap
(M8) (M10 x OD30mm)
Screwdriver and Allen Key
29 x 4 27 x 1
Flat Washer Flat Washer
(ID8.5 x OD13 x T1.5mm)
43 x 4 17 x 2
Hex Head Bolt
(M8 x 16mm)
51 x 2
www.yorkfitness.com
24 x 4 21 x 1
Nyloc Nut Round Allen Head Bolt
(M10) (M8 x 15mm)
22 x 2 28 x 2
Round Phillips Head Flat Washer
Machine Screw (ID8.5 x OD28 x T2mm)
(M5 x 6mm)
52 x 1
Multi Spanner (13, 17mm)
x 1
5
Stop Bracket
(56 x 20 x T2mm)
30 x 2
Plastic Spacer
(ID12.8 x OD19 x 38mm)
5