Setup; Factory Default Setting; Console; Web User - Soundwin VoIP Voice Gateway User Manual

2.3 Setup

There are 3 way to setting gateway - [Web User Interface] [Telnet] [Console] (Some Series
modules have RS-232 console port like S800/SB800/S1600/S2400).

2.3.1 Factory Default setting

WAN Port IP address : 192.168.1.1
LAN Port IP address : 222.222.222.1
LAN DHCP Server enable IP range: 222.222.222.51 ~ 222.222.222.100
VoIP Number(S200 Series) Port_1~Port_2 number:100,200
VoIP Number(S400 Series) Port_1~Port_4 number:100,200,300,400
VoIP Number(S800 Series) Port_1~Port_8 number:100,200,300,400,500,600,700,800
VoIP Number(SB800 Series) Port_1 ~ Port 8 number : 101~ 108
VoIP Number(S1600 Series) Port_1 ~ Port 16 number: 101~ 116
VoIP Number(S2400 Series) Port_1 ~ Port 24 number: 101~ 124
VoIP default setting was H.323 signal protocol, Direct Mode, Fast-Start and G.723 codec.
Default login authentication username : admin, password : admin

2.3.2 Console

RS-232 port (DB-9pin male connector), Configure the COM Port Properties as following: Bits
per second: 9600, Flow control: None
1. Connect Gateway RS-232 port to PC COM Port.
2. Power on gateway.
3. Open Terminal Program (ie. Windows XP Hyper Terminal)
[Start] → [Program file] → [Accessories] → [communications] → [Hyper Terminal]
4. Create New connection. Select "Com" port that connect PC to gateway
24