Soundwin VoIP Voice Gateway User Manual page 23

LAN(Local Area Network)
RES(Reset button)
AC power(DC in 12V)
Call Manager ONLY
Connect the cord to FXS port
Connect the PSTN line to PSTN port
Connect the PBX to phone port
The hardware installation is now complete. The following sections will guide you through setting
up your management PC and connecting to the Web User Interface.
allows your GW to be connected to an Internet Access
device, e.g. router, cable modem, ADSL modem, through a
networking cable with RJ-45 connectors used on 10BaseT
and 100BaseTX networks.
Connect to PC with Ethernet cable. 1 port allows your PC or
Switch/Hub to be connected to the GW through a networking
cable with RJ-45 connectors used on 10BaseT and
100BaseTX networks.
Push this button until 3 seconds, and GW will be set to
factory default configuration.
A power supply cable is inserted
23