Soundwin VoIP Voice Gateway User Manual page 14

S800 (GW/GK/SVR) Series & C800 Call Manager
Item Port
1 FXS(Foreign Exchange Station)
2 FXO(Foreign Exchange Office)
3 WAN(Wide Area Network)
4 LAN(Local Area Network)
5. Switch power
6 AC power(DC in 12V)
7 RS-232
8 RES(Reset button)
*there is no FXO port in Call Manager
Description
Connect to Phone with RJ-11 (Black) analog line.
FXS port was connected to your telephone sets, FAX,
or Trunk Line of PBX.
Connect to PBX or CO line with RJ-11(Write) analog
line. FXO port was connected to the extension port of
a PBX or directly connected to a PSTN line of carrier.
Connect to the network with an Ethernet cable. This
port allows your GW to be connected to an Internet
Access device, e.g. router, cable modem, ADSL
modem, through a networking cable with RJ-45
connectors used on 10BaseT and 100BaseTX
networks.
Connect to PC with Ethernet cable. 1 port allow your
PC or Switch/Hub to be connected to the GW through
a networking cable with RJ-45 connectors used on
10BaseT and 100BaseTX networks.
Power Switch, turn on/off the GW power supplied. [I]
is turn on the power, and [o] is turn off the power.
A power supply cable is inserted.
The supplied power adapter converts
110V or 220V AC to DC as required for this device.
RS-232 console port connect to PC, Use Pc com port
to connect RS-232 console , setting GW configure.
The reset button, when pressed, resets the cable
voice gateway without the need to unplug the power
cord.
Push this button until 5 seconds, and GW will be set
to factory default.
14