Soundwin VoIP Voice Gateway User Manual page 15

SB800/S1600/S2400 Series Gateway
Item Port
1 Standard Telco 50 PIN
Connector (RJ-21)
2 RES(Reset button)
3 RS-232
4 WAN(Wide Area Network)
5. LAN(Local Area Network)
6 Switch power
7 AC power(DC in 12V)
8 LCD Panel
Description
It is a 50 pins RJ-21 connector for connecting to
telephone patch pane
The reset button, when pressed, resets the cable
voice gateway without the need to unplug the power
cord.
Push this button until 5 seconds, and GW will be set
to factory default.
RS-232 console port connect to PC, Use Pc com port
to connect RS-232 console , setting GW configure.
Connect to the network with an Ethernet cable. This
port allows your GW to be connected to an Internet
Access device, e.g. router, cable modem, ADSL
modem, through a networking cable with RJ-45
connectors used on 10BaseT and 100BaseTX
networks.
Connect to PC with Ethernet cable. 1 port allow your
PC or Switch/Hub to be connected to the GW through
a networking cable with RJ-45 connectors used on
10BaseT and 100BaseTX networks.
Power Switch, turn on/off the GW power supplied. [I]
is turn on the power, and [o] is turn off the power.
A power supply cable is inserted.
The supplied power adapter converts
110V or 220V AC to DC as required for this device.
Setting GW and view GW status, use [up/down]
button to select Menu, and [menu] button return to
main and click select.
15