Rear Panel Descriptions - Soundwin VoIP Voice Gateway User Manual

Flashing Ring Indication
On
-------------------------------------------------------------------------------------
6. FXO(Port) Off
On
-------------------------------------------------------------------------------------
6. LCD Panel Off
On
NOTE: System initialization will turn some LEDs ON for a few sec.
When System Boot/Reboot , the Port LEDs will flash in turn for a few sec.

1.4.3 Rear Panel Descriptions

L200(GW/GK/SVR) Series
Item Port
1 FXS(Foreign Exchange Station)
2 FXO(Foreign Exchange Office)
3 WAN(Wide Area Network)
4 LAN(Local Area Network)
5 RES(Reset button)
6 AC power(DC in 12V)
Telephone Set is Off-Hook
Line is not enabled
Line is busy
System is Shutdown
System is Up
Description
FXS port can be connected to analog telephone sets
or Trunk Line of PBX.
Can be Connected to PBX or CO line with RJ-11
analog line. FXO port can be connected to the
extension port of a PBX or directly connected to a
PSTN line of carrier.
Connect to the network with an Ethernet cable. This
port allows your ATA to be connected to an Internet
Access device, e.g. router, cable modem, ADSL
modem, through a networking cable with RJ-45
connectors used on 10BaseT and 100BaseTX
networks.
Connect to PC with Ethernet cable. 1 port allows your
PC or Switch/Hub to be connected to the ATA
through a networking cable with RJ-45 connectors
used on 10BaseT and 100BaseTX networks.
Push this button until 3 seconds, and ATA will be set
to factory default configuration.
A power supply cable is inserted
12