Table of Contents
Advertisement
Chapter 6
CAUTION
Follow these instructions to remove and replace the processor fans:
1. Back up the hard disk drive(s) and save the configuration.
2. If necessary, shutdown the network operating system.
3. Turn off the HP NetServer and display.
4. Disconnect all telephone cables and power cords.
5. Remove the right side cover (HP NetServer LH 6000) or the bottom cover (HP NetServer LH
6000r).
6. Remove the individual fan assembly by pressing the handles and pulling the assembly out of
the chassis.
Install the new fan assembly by using the above procedures in reverse.
Do not run this NetServer for more than 60 minutes without all covers in place. Any
component being replaced must be removed and a replacement installed within this
60-minute time window. If you feel that you cannot, in your estimate, replace any
particular component within this time, first turn off power to the system and then
replace the component. Failure to replace the covers within 60 minutes may result in
damage to system components due to lack of cooling air.
Removing a Processor Fan
Replacing Parts
93
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
