Front Panel Console Switch And Indicator Descriptions - HP Officejet LH 6000 Service Manual

Chapter 1

Front Panel Console Switch and Indicator Descriptions

Control
DC Power Switch
and LED
RESET RESET
Or
Secure Mode
Switch and
Indicator
Status screen
Red Yellow
LED LED
Off Off
Flashing Off
Off Flashing
Off Off
Turns the HP NetServer on and off. This switch is under the door on the front panel.
Push once to turn on, again to turn off. As long as the AC power is connected to the
HP NetServer, standby power is present.
If the LED is steady green, then the HP NetServer is powered-up.
l
If the LED is flashing green, the HP NetServer is in a power-save mode.
l
If the LED is off, but the two-line display has a message, standby power is
l
present.
To go into power-save mode, depress the power switch; you must press it for
l
over ten seconds to effect a power down.
Resets the HP NetServer. This switch may be disabled by Secure mode.
Locks system keyboard, monitor display, and control panel to prevent unauthorized
use. Go to the Setup utility security menu to configure this feature. Secure Mode
indicator illuminates when Secure Mode is enabled.
Reports system status.
Green
LED
Off Main power is off and the HP NetServer may or may not be on standby
power.
Off Immediate attention required due to a failed component in the HP
NetServer. The HP NetServer may not be fully operational, due to this
condition, such as POST errors.
Off Attention required due to a pre-failure condition. This condition may be
caused by a component failure (for example, a redundant fan or power
supply) that could lead to a critical component failure, such as a processor
module exceeding its operating temperature. If the failed component is
redundant, the HP NetServer may still be operating normally.
On The HP NetServer is operating normally.
Description
Indicates HP NetServer Status:
General Information
11