HP Officejet LH 6000 Service Manual page 93

Chapter 6
9. Identify the slot location for the DIMM being replaced.
10. Remove and Replace the DIMM:
a. Spread the latches outward on each socket receiving a DIMM.
b. Remove a DIMM, handling the module by its edges.
c. Align the notches on the replacement DIMM with the slot keys on the socket.
d. Press the DIMM into the socket until the latches close.
CAUTION
NOTE
Slot 1A and Slot 1B
Slot 2A and Slot 2B
Slot 3A and Slot 3B
Slot 4A and Slot 4B
Do not rock the DIMM into place, but apply firm and even pressure. If a gap exists
between the retaining latches and the DIMM, remove the module gap.
Insert DIMMs in Matched Pairs
DIMM
Align DIMM Notches with slot keys
If the latches do not close, repeat until they do.
Paired Memory Slots
Notches
Keys
Retaining
Clips
Replacing Parts
87