Table of Contents
Advertisement
2 System Information
Boot Priority
Some boards have preferred slot locations. Consider the boot order when choosing the accessory board slot
in which to install the accessory board.
This is the default boot priority for the LH 6000/6000r:
1. IDE CD-ROM drive with a bootable CD-ROM
2. Flexible disk drive with a bootable flexible disk
3. HP NetRAID controller or integrated Embedded SCSI controller
4. PCI boards in slots in the following order: 8, 7, 6, 5, 4, 3, 2, and 1
Change this boot order using the Setup utility.
IRQ Settings
The BIOS automatically assigns the IRQs (hardware interrupts) for each PCI slot and embedded device in
the HP NetServer during boot. These assignments trigger the NOS to enable the APIC (Advanced
Programmable Interrupt Controller). APIC takes advantage of the expanded set of non-conflicting IRQs for
those accessory boards requiring more than one IRQ per slot. APIC provides up to four dedicated interrupts
for each PCI slot.
These automatic IRQ assignments can be changed in the setup screen (F2).
Connector Pinouts
Unless otherwise noted, the following features apply to all models. Some features are factory installed;
others are optional.
Video Connector Pinouts
The built-in video uses the standard 15-pin analog display pinout configuration. The pinouts for your monitor
may vary. For the pinouts for your monitor, refer to the manual that came with your monitor.
6
1
7
2
8
3
9
4
10
5
Video Connector Pinouts
11
12
13
14
15
17
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
