Table of Contents
Advertisement
Chapter 1
2. Remove the bezel from the front of the HP NetServer by swinging the bezel open (past 90
degrees) until it releases from the three posts on the bezel hinge.
3. Use a Torx 15 screwdriver to unscrew the four screws securing the HP NetServer to the rack.
4. Do not unscrew the entire hinge or bracket from the HP NetServer. Remove only the outer
screws so the hinge and the bracket remain attached to the HP NetServer chassis.
4
Leveler
Feet
Rack Anti-tip Foot
Removing the HP NetServer LH 6000r Bezel
Anti-Tip
Foot
General Information
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
