Hearth Support, Standard Surround - Quadra-Fire CASTILEI-MBK Owner's Manual Installation And Operation

Castile Pellet Insert
F. Hearth Support For Standard Surround Only
Figure 20.1 - Assembled View
1
2
3
Figure 20.2
Item
1 Front, 3 inch
2 Front, 5 inch
3 Cast Ring, Top & Bottom, Interchangeable
4 Side, 5 inch
5 Side, 3 inch
6 Panel Extension, 5 inch
7 Panel Extension, 3 inch
8 Panel Extension, Base Plate Only
1. Remove contents from box and lay on protective surface to
avoid scratching the paint.
2. Lay hearth support's front and sides face down. Bend the
tab down toward the inside.
3. The side pieces are shipped fl at. It is much easier to manually
fl ex the sides into a bowed position before installing.
4. Lay 1 cast ring face up, which will become the bottom ring when
installed. Attach the 2 sides FIRST and then the front piece.
Figure 20.3.
5. Now turn the cast ring right side up and attach the top cast
ring . Figure 20.4.
6. Attach the hearth support's panel extensions. Figure 20.5
7. Attach cast footers. Figure 20.6.
8. Place the assembled hearth support under the insert. Figure
20.7.
Page 20
8
7
6
4
Description
Install Front Last
Bend top and bottom tabs toward inside
Figure 20.3
5
Turn right side up and attach top cast ring
Figure 20.4
Alignment
Hole
Figure 20.5
Cast Trim Footer
Figure 20.6
Panel Leg
Figure 20.7
7022-122D
Panel Extension
May 12, 2014