How To Read The Battery Meter; How To Change Display Screens On The Lcd Module; How To Read The Solution Empty Indicator; How To Read The Recovery Full Indicator - Clarke 00310S Operator's Manual

How To Operate the Machine
How to Read the Battery Meter (see fi gure 21, A)
The battery meter is an indicator on the LCD display. This indicator is
on the LCD display on the front of the machine. It has 10 bars with 10
bars visible indicating a full charge. As you run the machine the bars
will begin to lower. The "Battery Icon" (B) will begin to fl ash to indicate
you are reaching the end of charge.
NOTE: If you continue to run the brushes they will shut down to
protect the batteries from over discharging.
NOTE: Run times will vary depending on machine variables, bat-
tery size, brush pressure and fl oor type, etc.
How to Change Displays Screens on the LCD Module
The LCD display has three screens. Two of them can be accessed at
any time the key is on. The fi rst screen shows the machine status and
the second screen shows the four hour meters (fi gure 21).
The two screens that can be viewed by the operator can be accessed
via the display button (fi gure 22) on the control panel to the left of the
key switch. Pressing this button toggles the display between the avail-
able screens.
The third screen is for diagnostics only. This screen displays any errors
that might occur or if the system diagnostics fi nds something wrong.
When the diagnostic screen comes up, refer to the trouble shooting
guide for suitable action to resolve the error code.
How to Read the Solution Empty Indicator (see fi gure 23, A)
The solution empty indicator is located on the front of the machine
below the LCD display. When the solution reaches nearly empty, the
indicator will begin to fl ash, warning the operator of the need to refi ll.
NOTE: Solution run times will vary depending on solution fl ow
setting.
How to Read the Recovery Full Indicator (see fi gure 23, B)
The recovery full indicator is located on the front of the machine below
the LCD display. When the recover tank is near full the indicator will
begin to fl ash, warning the operator of the need to empty the recovery
tank. The vacuum motors will shut down a few moments later.
NOTE: Recovery times will vary depending on
Clarke ®
Operator's Manual (EN) - Focus Rider
ENGLISH
SCREEN 1
A
B
SCREEN 2
Figure 21
Figure 22
B
Figure 23
Form No. 71171A
EN
A
- 17 -