Table of Contents
Advertisement
Figure 5
Clarke
®
Operator's Manual - Fusion 27 Battery Burnisher
Figure 4
(Maximum level)
B
Correct Range
A
(Minimum level)
Plates
Battery
HOW TO PREPARE THE MACHINE
FOR OPERATION
How To Install The Batteries
The Fusion 27 machines uses six 6-volt batteries.
The batteries are located in the battery compartment
under the battery cover.
To Install the batteries, follow this procedure:
1. Turn key switch off.
2. Remove the battery cover.
3. Place the batteries in the body as
shown in figure 4.
WARNING:
Lifting batteries without
help could result in an
injury. Get help to lift the
batteries. The batteries are
heavy.
WARNING:
Working with batteries can
be dangerous. Always
wear eye protection and
protective clothing when
working near batteries.
NO SMOKING!
4. Connect the battery cables between
batteries as indicated. See figure 4.
NOTE: Charge the batteries before using the ma-
chine.
Battery Maintenance
The electrical power to operate the machine comes from
the storage batteries. Storage batteries need preventive
maintenance.
WARNING:
Working with batteries can be
dangerous. Always wear eye
protection and protective
clothing when working near
batteries. NO SMOKING!
To maintain the batteries in good condition, follow these
instructions:
1. Remove each cap to all of the cells of the batteries.
2. Check the electrolyte level in the batteries. The
minimum level is just above the tops of the plates.
See figure 5 A.
NOTE: Check the level of electrolyte prior to charg-
ing the batteries.
EN
- 21 -
Advertisement
Table of Contents
