How To Change Or Rotate Brushes On Cylindrical Brush Head - Clarke 00310S Operator's Manual

ENGLISH EN
How To Prepare the Machine For Operation

How To Change or Rotate Brushes on Cylindrical Brush Head

To install or rotate brushes on the cylindrical brush head:
1. Raise the brush deck and turn the key switch "OFF".
2. Raise the brush skirt and pull out to remove. See fi gure 11.
3. Remove thumb screw from brush door. See fi gure 12.
4. Lower door approximately 1/2 inch and slide door and hub
assembly from brush. See fi gure 13.
5. Slide brush off hub at opposite end. See fi gure 14.
6. Rotate brush or replace.
7. Slide brush on drive hub and insert door and hub assembly
into brush core.
8. Raise door and install thumb screw.
9. Place side skirt on retainer pins and lower in place.
Page -14- Form No. 71171A
Figure 11
Figure 12
Figure 13
Figure 14
Clarke ®
Operator's Manual (EN) - Focus Rider