Do These Procedures When You Begin Your Work Period - Clarke 00310S Operator's Manual

ENGLISH EN
How To Operate the Machine (cont.)
To traverse the machine follow this procedure:
1. Sit on the driver seat. NOTE: The machine will not traverse if the
operator is not properly seated.
2. Turn the key switch to the "ON" position.
3. Raise the brush to the highest position (if necessary).
4. Raise the squeegee (if necessary).
5. Gently press the foot pedal and the machine will begin to move.
6. To stop, release pressure on the foot pedal.
7. To travel in reverse, select reverse with the forward/reverse switch.
8. To stop, release pressure on the foot pedal.
9. When you stop the machine, turn the key switch "OFF" and remove
the key.

Do These Procedures When You Begin Your Work Period

1. Make sure the key switch is in the "OFF" position.
2. Disconnect AC power from battery charger (follow charger instruc-
tions).
3. Make sure the fi lter screen (1) to the vacuum motor is clean and
installed properly in the recovery tank (see fi gure 30).
4. Make sure the recovery tank lid is in place and has been tightened
(see fi gure 31).
5. Close and secure the lower cleaning port cover (if so equipped) on
the recovery tank.
6. Make sure that the plug in the recovery drain hose is in place and
has been tightened (see fi gure 32).
7. Make sure that the brushes/pads are in position and installed cor-
rectly.
8. Make sure the brush housings are in position on the brush head.
9. Check the installation of the squeegee and squeegee hose.
Page -20- Form No. 71171A
Figure 30
Figure 31
Figure 32
Clarke ®
Operator's Manual (EN) - Focus Rider