Table of Contents
Advertisement
How To Prepare the Machine For Operation
5.
Remove the clamping knobs and the side brush housings with
skirts from the brush head unit.
6.
Disconnect the solution hose quick connect coupling from the
machine.
7.
Loosen the two knobs on the clamping studs located on the left
side of the machine. Rotate the two studs outward from the
center of the brush head unit.
8.
With the brushes still on the unit, carefully pull the brush head
unit towards you and slide the unit out of the machine.
How to Install the Cylindrical Brush Head Unit (see figure 26)
To install the cylindrical brush head unit, follow this procedure:
1.
Se the parking brake.
2,
Position the brush head unit on the left side of the machine, with
the brushes, side skirts and hopper removed.
3.
Align the mounting rails of the machine with the channels on the
brush head unit (see figure 27).
4.
Turn the key switch to the "ON" position.
5.
Raise or lower the mounting rails on the machine using the
brush up/down switch such that the channels on the brush
head align in the vertical direction.
6.
Turn the key switch to the "OFF" position.
7.
Carefully slide the brush head unit into the machine until it stops.
NOTE: The electrical connections between the brush motors
and the machine are connected automatically once the brush
head is fully inserted into the machine.
8.
Rotate the two clamping studs (with knobs), located on the left
side of the machine, towards the inner part of the brush head
unit (see figure 28).
9.
Secure the brush head unit into the machine by tightening the
two knobs.
10. Attach the solution hose quick connect coupling to the machine
(see figure 29).
11. Install the brushes, hopper and side skirts.
How to Install the Cylindrical Brushes
1,
Set the parking brake.
2.
Connect the battery pack connector into the machine
connector.
3.
Turn the key to the "ON" position.
4.
Push the brush up/down switch to raise the brush head.
5.
Turn the key to the "OFF" position. Remove the key from
the machine.
WARNING:
Injury could occur if you do not remove
the power source from the machine
before you assemble the brushes.
Operator's Manual
Clarke
®
-MINI MAX
Figure 26
Figure 27
Figure 28
Figure 29
Page -15-
Advertisement
Table of Contents
