AMX MXT-1000 Operation/Reference Manual page 25

#4 Screws
FIG. 16 MXD-1000 Back Box Installation (Portrait)
4.
Thread the incoming Ethernet and Micro-USB wiring (if Micro-USB access is desired) from their
terminal locations through the surface opening (FIG. 16 ). Leave enough slack in the wiring to
accommodate any re-positioning of the panel.
5.
Remove the back box knockouts (FIG. 16) and thread the incoming wiring through the knockout holes.To
facilitate installation, thread the Ethernet cable through a bottom knockout (Landscape) or a right-side
knockout (Portrait), and the Micro-USB or USB cables through a top knockout (Landscape) or left
knockout (Portrait)
6.
Thread the incoming Ethernet, USB, and Micro-USB wiring (if USB or Micro-USB access is desired)
from the surface opening and through the knockouts.
7.
Push the back box into the mounting surface. Insure that the locking tabs lie flush against the back box
and that the back box goes freely into the opening.
8.
Extend the locking tabs on the sides of the back box by tightening the screws inside the box until snug.
Not all of the tabs must be extended to lock the back box in place, but extending a minimum of the top
and bottom tabs is highly recommended. Apply enough pressure to the screw head to keep the box flush
with the wall: this ensures that the locking tabs will tighten up against the inside of the wall.
The back box is clear to allow visual confirmation that the tabs have been extended and are gripping the
wall, as well as in assisting with removal if necessary.
9.
For additional strength, #4 mounting screws (not included) may be secured through circular holes located
at the left and right sides of the MXD-1000 (FIG. 16). In order to prevent damage to the touch panel,
make sure that these are flush with the back box.
10.
Insert each connector into its corresponding location along the back of the device (FIG. 17). To reach the
RJ45 connector, gently pull it from beneath the electronics cover (FIG. 18). Attach the Ethernet cable and
gently push the connection back under the cover.
MXD/T-1000 10.1" Modero® X Series Touch Panels
Locking
Tabs
Back Box
Installation
Mounting Surface
Knockouts
17