Replacing Memory Modules; Preliminary Steps; Removing A Memory Module; Installing A Memory Module - Fujitsu PRIMERGY CX272 S1 Upgrade And Maintenance Manual

Main memory
7.4

Replacing memory modules

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver (preliminary and concluding
steps), tool-less
7.4.1

Preliminary steps

Perform the following steps:
"Installing the memory slot air ducts" on page 45
Ê
"Installing the air duct brackets" on page 47
Ê
"Installing the air duct" on page 49
Ê
"Installing the server node in the Dual Node Cluster Server" on page 72
Ê
Ê If applicable, reconnect all external cables.
"Switching on the server node" on page 73
Ê
"Updating or recovering the system board BIOS and BMC" on page 77
Ê
applicable)
"Enabling boot watchdog functionality" on page 84
Ê
"Verifying the memory mode" on page 85
Ê
7.4.2

Removing a memory module

Ê Identify the defective memory slot.
Ê Remove the defective memory module as described in section
memory modules" on page
7.4.3

Installing a memory module

Ê Install the new memory module as described in section
modules" on page
154
151.
148.
Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 5 minutes
(if applicable)
"Installing memory
(if
"Removing
CX272 S1