Removing A Memory Module; Concluding Step - Fujitsu PRIMERGY CX272 S1 Upgrade And Maintenance Manual

Main memory
7.3.2

Removing a memory module

Figure 83: Removing memory modules
Ê Eject the desired memory module by pressing out the securing clips at each
end of the memory module connector (1).
Ê Remove the ejected memory module (2).
Figure 84: Removing memory modules (B)
7.3.3

Concluding step

Perform the following steps:
"Installing the memory slot air ducts" on page 45
Ê
"Installing the air duct brackets" on page 47
Ê
"Installing the air duct" on page 49
Ê
"Installing the server node in the Dual Node Cluster Server" on page 72
Ê
Ê If applicable, reconnect all external cables.
"Switching on the server node" on page 73
Ê
"Updating or recovering the system board BIOS and BMC" on page 77
Ê
applicable)
152 Upgrade and Maintenance Manual
(if
CX272 S1