Symptom
Machine will
not turn on:
There is power, but the
rollers are not turning after the
"RUN" button is
pressed:
The unit is not heating up
Curled lamination:
Unclear lamination:
12. TROUBLESHOOTING
Cause
a. Power switch is in "0" (Off)
position
b. Tripped circuit breaker.
c. Blown main power fuse.
a. Safety cover is not closed.
b. Blown motor fuse.
Call your authorized
dealer
a. Upward curl.
b. Downward curl.
The main roller temperatures are too
low and/or lamination speed is too fast.
12
Possible Solution
a. Put the power switch to the
"I" (On) position
b. Reset the circuit breaker.
c. Replace the fuse.
a. Close the safety cover to
active the safety switch.
b. Replace the motor fuse.
Call your authorized dealer
a. Loosen the top roll film tension.
b. Loosen the bottom roll
film tension.
c. Please put the lamination
pass through the DE-CURLING
bar for Single laminating
Raise the roller
temperatures and/or
lower the lamination speed.