Table of Contents
Advertisement
6.2. HOT FILM SINGLE SIDED LAMINATING
LAMINATING HOT ROLLERS
1. Turn the power switch on("I" position). Power switch is located in the rear of the unit on the left side.
2. Follow the steps in the "Loading Film" procedure by loading the upper shaft with OPP Film.
3. Set the temperature and speed as shown as the recommended in page 13.
4. Center the OPP film.
5. Thread the film under the Upper Idle Bar and underneath the Safety Cover until the film rests on
the upper hot roller.
6. Pull a sheet of A3 paper into the laminating roller and pass under the idle-bar
and over the shaft-decurling bar. Make sure the idle-bar being in the lower location while laminating.
7. Link the paper to the film.
8. Adjust the nip setting to "Laminating" mode.
9. Press the run button and adjust the supply roll tension knobs by rotating clockwise or counterclockwise.
Turn it until the supply roll films have some resistance(the tension varies depending on the film thickness:
the thicker the film the more tensions is required) (Picture 6).
10. St op t he l ami nat or when all of t he laminated i t ems hav e c ompl et ely exi t ed t he
rear of t he machine.
ROLL FILM
ADHESIVE SIDE
IDLE BAR
IDLE BAR
SHAFT DE-CURLING BAR
GLOSSY SIDE
PULL ROLLERS
7
Advertisement
Table of Contents
