Table of Contents
Advertisement
LED Display
1. TEMPERATURE DISPLAY: Display current temperature.
2. SPEED DISPLAY: Display current Speed.
3. To change the roller's temperature up or down.
o
o
(Range 110 C-150 C and 5 degree for a level.)
4. To change the speed of rollers. (Range 1-9)
5. REV: To reverse the rollers. Must press and hold the button to activate.
6. RUN /STOP: To start or stop the rollers from turning.
7. S/D: Single laminating/Double laminating.
NOTE: *1.Only one roller is heating while turning on the main power switch. Please press
the button "S/D" for two sides laminating and the LED-light is bright at once.
*2. STAND-BY MODE and AUTO POWER OFF MODE
STAND-BY MODE: If no activity is made within 30 minutes after each use the machine
will automatically switch into stand by mode (In stand-by mode the temperature will
decrease to 80~90 °C (176~194°F) and every other LED light of the temperature and
speed will be lit.
AUTO POWER OFF MODE: If the machine is in stand by mode and no activity is made
for 60 minutes the machine will automatically power off (Only the No.1 speed LED lights).
-If any activity is made while in stand by or auto power off mode the machine will return to
it's previous stage.
8. CONTROL PANEL
9
150˚C
140˚C
1
2
130˚C
120˚C
110˚C
3
4
5
6
7
Advertisement
Table of Contents
