5-10 Jumper Settings; Explanation Of Jumpers; Cmos Clear; Lan1/2 Enable/Disable - Supero SUPERSERVER 5015A-L User Manual

S S
UPER ERVER 5015A-L/5015A-H User's Manual

5-10 Jumper Settings

Explanation of Jumpers

To modify the operation of the mother-
board, jumpers can be used to choose
between optional settings. Jumpers
create shorts between two pins to
change the function of the connector.
Pin 1 is identifi ed with a square solder
pad on the printed circuit board. See
the motherboard layout pages for
jumper locations.
Note: On a two-pin jumper, "Closed"
means the jumper is on both pins and
"Open" means the jumper is either on
only one pin or completely removed.

CMOS Clear

JBT1 is used to clear CMOS (which will also clear any passwords). Instead of pins,
this jumper consists of contact pads to prevent accidentally clearing the contents
of CMOS.
To clear CMOS,
1. First power down the system and unplug the power cord(s).
2. With the power disconnected, short the CMOS pads with a metal object such
as a small screwdriver.
3. Remove the screwdriver (or shorting device).
4. Reconnect the power cord(s) and power on the system.
Note: Do not use the PW_ON connector to clear CMOS.

LAN1/2 Enable/Disable

Change the setting of jumper JPL1
and JPL2 to enable or disable the
LAN1 and LAN2 Ethernets ports, re-
spectively. See the table on the right
for jumper settings. The default setting
is enabled.
Connector
Pins
Jumper
Setting
LAN1/2 En/Disable Jump-
er Settings (JPL1/JPL2)
Jumper Setting
Pins 1-2
Pins 2-3
5-14
3 2 1
3 2 1
Defi nition
Enabled
Disabled