Checking The Drive Bay Setup - Supero SUPERSERVER 5015A-L User Manual

S S
UPER ERVER 5015A-L/5015A-H User's Manual
2-6

Checking the Drive Bay Setup

Next, you should check to make sure the drives have been properly installed and
all essential connections have been made.
Checking the Drives
1. Refer to Chapter 6 if you need to reinstall a DVD-ROM drive to the system.
2. Depending upon your system's confi guration, your system may have one or
two Serial ATA drives already installed. If you need to install Serial ATA drives,
please refer to the appropriate section in Chapter 6.
Providing Power
1. The last thing you must do is to provide input power to the system. Plug the
power cord from the power supply unit into a high-quality power strip that of-
fers protection from electrical noise and power surges. It is recommended that
you use an uninterruptible power supply (UPS).
2. Finish by depressing the power button on the chassis control panel.
2-8