Section 15: Installing The Radio - Hangar 9 Piper Cherokee Instruction Manual

Section 15: Installing the Radio

Parts Needed
• 4-channel radio system with four servos and hardware
(not included)
• Fuselage
• Radio packing foam (not included)
• Antenna tube (not included)
Aileron Servo Installation
Step 1. Install the rubber servo grommets and eyelets in the
aileron servo and place the servo into the aileron mount as
shown. Using a pencil, mark the position of the four servo
mounting holes.
Step 2. Remove the servo from the aileron tray. Using a 1/16''
drill bit, drill the four mounting holes as marked in the previous
step.
Tools and Adhesives Needed
• Drill
• 1/16'' drill bit
• Small Phillips screwdriver
• Hobby knife
• Pencil
• Felt tipped pen or pencil
Step 3. Place the aileron servo back in its mount and secure it
in place using the four screws included with the servo.
Rudder, Elevator, and
Throttle Servo Installation
Step 4. Install the rubber grommets and eyelets in the three
remaining servos. Position the servos in the fuselage servo tray
as shown.
Important Note: Note the location of the output horns.
Using a pencil, mark the 12 servo
mounting hole positions.
41