Hangar 9 Piper Cherokee Instruction Manual page 48

Section 16: Installing the Linkages
Step 33. Using Z-bend pliers, make a Z-bend at the marked
spot on the rod. Remove the excess rod.
Step 34. Attach the Z-bend to throttle servo arm.
Nose Wheel Linkage
Step 35. Locate the remaining long (17-3/4'') threaded rod and
clevis.
Step 36. Locate the hole in the firewall near the nose wheel
steering arm.
Step 37. Insert the threaded rod, threaded end first, through the
nose wheel linkage slot and into its respective 1/16'' guidance
hole in the fuselage.
Step 38. Screw on a clevis 12 full turns. Fasten the clevis in the
outermost servo arm hole opposite the rudder servo Z-bend.
48
Step 39. Be sure that the rudder servo is centered. Using a felt
tipped pen, place a mark on the unthreaded end of the steering
pushrod where it passes the nose wheel steering arm.
Step 40. Using a Z-bend pliers, make a Z-bend at the marked
location on the rod. Cut off the excess rod.
Step 41. Insert the Z-bend into the outermost hole on the nose
gear control horn. It may be necessary to loosen the nose gear
assembly during installation of the Z-bend.
CONTINUED