Hangar 9 Piper Cherokee Instruction Manual page 16

Section 3: Installing the Aileron Servo Tray
Step 11. Mix a small amount of 6-minute epoxy and apply it to
one of the aileron servo supports between the two tabs. Position
the aileron servo tray in place as shown and lightly spread epoxy
along the joint between the aileron servo tray and the aileron
servo support.
Note: If desired, thick CA may be used in this procedure
instead of epoxy.
16
Step 12. Repeat this procedure for the opposite aileron servo
support. Make sure the aileron servo support and the servo tray
remain perpendicular to one another. Allow the epoxy or CA to
dry completely before proceeding to the next step.
Step 13. Mix a small amount of 6-minute epoxy to glue the
servo tray into the wing. Using an epoxy brush, apply the epoxy
to the aileron servo supports. Insert the assembled unit into its
receptacle in the wings. Remove any excess epoxy with a paper
towel and rubbing alcohol and allow the epoxy to cure.
Important Note: The shorter aileron support must be
located closest to the trailing edge of the
wing.
CONTINUED