Connecting An Lc-Lc Cable To An Sfp Module; Removing The Fiber-Optic Cable Protective Caps - IBM TotalStorage DS4400 User Manual

Connecting an LC-LC cable to an SFP module

To connect an LC-LC Fibre Channel cable to an SFP module, complete the
following steps.
Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could
v Use of controls or adjustments or performance of procedures other than
DANGER
1. Read the information in "Handling fiber-optic cables" on page 5.
2. If necessary, remove the protective cap from the SFP module, as shown in
3. Remove the two protective caps from one end of the LC-LC cable as shown in
Figure 7. Removing the fiber-optic cable protective caps
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
those specified herein might result in hazardous radiation exposure.
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following. Laser radiation when open. Do not stare into the
beam, do not view directly with optical instruments, and avoid direct
exposure to the beam.
Figure 49 on page 61. Save the protective cap for future use.
Figure 7. Save the protective caps for future use.
Fiber-optic
cable
Protective cap
7
Chapter 1. Introduction