Ip Arp Inspection Recover - TP-Link JetStream TL-SL3452 Reference Manual

of a specified port. To restore to the default speed, please use no ip arp
inspection limit-rate command.
Syntax
ip arp inspection limit-rate value
no ip arp inspection limit-rate
Parameter
value ——The value to specify the maximum amount of the received ARP
packets per second, ranging from 10 to 100 in pps(packet/second). By default,
the value is 15.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEhternet)
Example
Configure the maximum amount of the received ARP packets per second as 50
pps for Fast Ethernet port 5:
TL-SL3428(config)#interface fastEthernet 1/0/5
TL-SL3428(config-if)#ip arp inspection limit-rate 50

ip arp inspection recover

Description
The ip arp inspection recover command is used to restore a port to the ARP
transmit status from the ARP filter status.
Syntax
ip arp inspection recover
Command Mode
Interface Configuration Mode (Interface fastEthernet / Interface range
fastEthernet / Interface gigabitEthernet / Interface range gigabitEhternet)
Example
Restore Fast Ethernet port 5 to the ARP transmit status:
TL-SL3428(config)#interface fastEthernet 1/0/5
TL-SL3428/TL-SL3452
62
JetStream L2 Managed Switch CLI Guide