Replacing The Projection Lamp - Kodak 2400 DV Plus User Manual

Replacing the
projection lamp
A-61316 April 2010
Use the following procedure to replace the projection lamp whenever a
reduction in brightness on the screen is detected or the lamp burns out.
Make sure that the replacement lamp is specified for use with this
scanner (DC20V 150W DDL type).
If the projection lamp burns out during a print operation, an L2 code
appears and the print job will stop (a blank piece of paper may be
output depending upon the stage of the job).
Once the system detects that the projection lamp has burnt out, the
scan job will be cancelled. If the system is operating in the Cycle Print
mode, the scanner operation will stop.
1. Turn the power switch off.
WARNING: Never touch the lamp with bare hands just after
operation or immediately after turning it off.
2. Slide out the projection lamp unit.
3. Remove the projection lamp from with the lamp holder.
4. Remove the projection lamp from the lamp socket.
5-3