Troubleshooting/Messages; Printer/Scanner Malfunctions - Kodak 2400 DV Plus User Manual

6 Troubleshooting/Messages

Printer / Scanner
malfunctions
A-61316 April 2010
This chapter contains information on analyzing and correcting operating
problems or errors that may occasionally arise during the use of the
Kodak 2400 DV Plus Digital Scanner.
Code
Power to the printer is off or there is a problem with the
connection of the interface cable to the printer.
• Turn on the printer and make sure that the interface cable is
securely connected.
The upper cover of the printer is not closed.
• Make sure that it is completely closed.
The toner cartridge is not installed or is defective.
• Install a correct toner cartridge.
A different type of toner cartridge is set.
• Install a correct toner cartridge.
You are using an end-of-life (completely used) toner cartridge.
When the Start key is pressed again it prints. (When Clear/Stop
key is pressed, the print is cancelled.)
•
Replace the toner cartridge immediately
The printer is out of paper.
• Load some paper into the paper cassette.
Paper of the output bin was filled.
• Remove the paper from the output bin.
This blinks when the scanner is connected to the PC and is
ready for scanning.
• Press the Start key to start scanning.
The scanner is not connected to the PC.
• Turn on the PC or connect the scanner to the PC with the
interface cable.
The projection lamp is burned out.
• Turn the power off, unplug the power cord and replace the
lamp.
If the lamp goes out during a print cycle, a blank print may be
output.
The battery for Date Print has run down.
• Turn off the Date Print function or call your Kodak Service
Representative.
Magnification warning display
• You used the modification of the magnification by an electronic
zoom.
• When a standard magnification is not selected, this symbol will
be displayed.
Description
.
6-1