Power Source; Grounding; Space Requirements - Kodak 2400 DV Plus User Manual

Power source

Grounding

Space requirements

A-61316 April 2010
• Use a power source with minimal voltage fluctuation.
Power Source: 50Hz/60Hz
Voltage fluctuation: within ± 10%
Frequently fluctuation: within ± 3%
• Do not exceed the capacity of the outlet, especially when sourcing
other appliances from the same outlet.
• The outlet should be located near the unit and be easily accessible
so that the power cord can be unplugged immediately if necessary.
• NEVER connect any other appliances or machines by means of a
multiple socket to the outlet being used for the unit.
• If an extension cord is needed, use one with a capacity greater than
the power consumption of the unit.
• Make sure that the power cord and extension cord do not become
caught in any mechanism of the system. Do not allow either the
power or extension cord to become caught underneath the weight of
the unit.
To prevent electrical shocks caused by electrical leakage, always
ground the printer.
• Connect the grounding wire to the ground terminal of the outlet and a
grounding contact that complies with the local electrical standards.
• Never connect the grounding wire to a gas pipe, the grounding wire
for a telephone or a water pipe.
Scanner
Provide the following clearance between the wall and rear of the unit
and right and left sides to provide ample space for the ventilation ports
to dissipate heat.
503 mm 100 mm
100 mm
4 in. 19 3/4 in.
4 in.
100 mm
4 in.
1-3