Selecting The Resolution; Registering The Job Program; Calling The Job Program - Kodak 2400 DV Plus User Manual

Selecting the Resolution

Registering the Job
Program

Calling the Job Program

3-14
1. Press the Shift key and the Resolution key together. The current
resolution is displayed.
2. Press the Resolution key while holding down the Shift key to set
the resolution.
Connection mode
PR mode
PC mode
NOTE: 800 dpi can only be selected when the width of the scan area is
less than 220 mm.
The current setting can be set up to 3 program registration locations
(1J, 2J and 3J) for both the PR connection and the PC connection.
Once the Job Programs have been set, you can recall them as needed.
1. Press the Memory Input key in the Setting mode. 1J starts blinking.
To change the program registration location, press the Multi-Print
key. The display is cycled in order of 1J to 2J to 3J to 1J.
2. Select the program registration location (1J, 2J or 3J), and press the
Memory Input key again.
The program registration is over when all LEDs on the control panel
light up and the normal display is resumed.
To call a registered Job Program:
1. Press the Shift key and the Job Recall key together.
Each time the Job Recall key is pressed while the Shift key is held
down, the display is cycled in order of 1J to 2J to 3J.
When the desired setting is displayed, release the keys.
Resolution
600 dpi
200 dpi
300 dpi
400 dpi
600 dpi
800 dpi
A-61316 April 2010
Display
6H
2H
3H
4H
6H
8H