Using The Cycle Print Mode - Kodak 2400 DV Plus User Manual

Using the Cycle Print
mode
Value
Period (seconds)
A-61316 April 2010
This function automatically scans the next image following a preset
period of time. Images are manually loaded on the carrier glass in
between cycles.
Cycle Print mode is a system setting that must be entered by an Kodak
Service Representative.
This function is only available in the PR mode.
Specifying the interval between scanning operations
The chart below provides the time intervals that can be set between
scanning operations. The time interval is based upon how much time it
takes you to move, for example, a roll of film from frame-to-frame. Refer
to this table when making a value selection.
1 2 3
0.5 1.0 1.5
1. Press the Multi-Print key to change the value to A. This enables the
Cycle Print mode.
2. Press the Multi-Print key to set the interval of time between scan
operations (see the table above).
3. Press the Memory Input key to store the currently selected interval
setting of the Cycle Print mode into the memory.
Operating in the Cycle Print mode
After entering the Cycle Print mode, press the Start key.
• After the first scanning operation has finished, the system will
automatically scan the next image following a preset period of time.
The system will continue to operate until the Cycle Print mode is
canceled.
• The No. of Copies value flashes during the scanning and waiting
operations.
• The next scanning job can be started manually by pressing the Start
key before the system automatically initiates the same job.
To pause an operation during the Cycle Print mode: press the Clear key
(the No. of Copies value switches from a flashing display to a constant
display).
• While the Pause function is enabled, it is possible to exit the Cycle
Print mode by pressing the Clear key a second time (the value
displayed in the No. of Copies display will change to a 1).
4 5 6
2.0 2.5 3.0
7 8 9
3.5 4.0 4.5
0
5.0
3-13