Nortel 1120E User Manual page 30

Connecting the components
Figure 6: Cable routing tracks and mounting holes
Method A
8. Wall-mount your phone (optional). Your IP Phone 1120E can be
mounted either by: (Method A) using the mounting holes on the
bottom of the phone stand, or (Method B) using a traditional-style
wall-mount box with an RJ-45 connector and a 15-cm (6-inch) RJ-45
cord (not provided).
Complete steps 1-7, as needed, before you wall-mount your phone:
Method A: Press the wall-mount lever, and pull the phone away from
the stand, as shown in Figure 5.Using the stand cover (the part you
removed in step 1), mark the wall-mount holes by pressing the bottom
of the stand cover firmly against the wall in the location where you
wish to install the phone. Four small pins on the bottom of the stand
cover make marks on the wall. Use the marks as a guideline for
installing the wall-mount screws (not provided). Install the screws so
that they protrude 3 mm (1/8 inch) from the wall, and then install the
phone stand mounting holes over the screw heads as indicated in
Figure 4 (Method A). You may need to remove the phone from the
wall to adjust the lower screws. When the lower screws are snug,
install the phone on the mounting screws, and then tighten the top
screws.
30
Method B