Before You Begin; Connecting The Components Of The Phone - Nortel 1120E User Manual

Before you begin

CAUTION
Damage to Equipment
Do not plug your IP Phone 1120E into a regular telephone jack.
This results in severe damage to the IP Phone. Consult your
system administrator to ensure that you plug your phone into a
10/100/1000BaseT Ethernet jack.
CAUTION
Your IP Phone 1120E is designed for use in an indoor
environment only.

Connecting the components of the phone

WARNING Your IP Phone 1120E is shipped with the
base locked in position. To avoid damaging your phone,
press the wall-mount lever, located just under the
Handsfree key as indicated in Figure 7 on page 31, to
release the base and pull it away from the phone.
Use the following steps to connect the components of your phone.
1. Remove the stand cover. Pull upward on the center catch as
indicated in Figure 5, and remove the stand cover. The cable routing
tracks are now accessible.
Connecting the components
27