SOLE F80 Owner's Manual page 21

TREADBELT TRACKING ADJUSTMENT:
The performance of your treadmill is dependent on the frame running on a reasonably
level surface. If the frame is not level, the front and back roller cannot run parallel, and
constant belt adjustment may be necessary.
The treadmill is designed to keep the treadbelt reasonably centered while in use. It is
normal for some belts to drift near one side while the belt is running with no one on it.
After a few minutes of use, the treadbelt should have a tendency to center itself. If,
during use, the belt continues to move toward one side, adjustments are necessary.
TO SET TREADBELT TRACKING:
A 6 mm Allen wrench is provided to adjust the rear roller. Make tracking adjustments
from the left side only. Set belt speed at
approximately 2 to 3 mph. A small
adjustment can make a dramatic difference.
Turn the bolt only a 1/4 turn and wait a few
minutes for the belt to adjust itself. Continue
to make 1/4 turns until the belt stabilizes in
the center of the running deck. The belt
may require
periodic tracking adjustment depending on use and walking/running characteristics.
Some users will affect tracking differently. Expect to make adjustments as required to
center the treadbelt. Adjustments will become less of a maintenance concern as the belt
is used. Proper belt tracking is an owner responsibility common with all treadmills.
ATTENTION:
DAMAGE TO THE RUNNING BELT RESULTING FROM IMPROPER TRACKING /
TENSION ADJUSTMENTS IS NOT COVERED UNDER THE SOLE WARRANTY.
BELT / DECK LUBRICATION:
Do not re-lube with other than Sole lubricant. Sole provides one application with this unit.
See your Sole dealer for additional purchases. The use of some other lubricants may
destroy the deck surface or belt and will void warranty. Conditions exist beyond Sole's
control on belt / deck cleanliness which relates to friction.
You should apply the enclosed belt lubrication after approximately the first 50 hours of
operation. Use all the contents of one container (no more) and spread lubricant onto
middle portion (away from edges) of the deck (under treadbelt) along it's width. When
walked on, the belt will make certain an even coat is applied. Lubricant is not harmful to
the skin. Lube will be distributed properly by walking at 2 to 3 mph for 3 to 5 minutes on all
areas of the belt. Use handrails for support. The first few minutes you will be polishing
your deck and lubricating the belt backing. Do not run on a newly lubricated belt until
the above break-in procedure is done. If the treadmill belt/deck is kept reasonably
clean it is possible to expect over 1000 hours before additional re-lubing is necessary.
CAUTION - KEEP HANDS CLEAR OF MOVING REAR PULLEY!
20
F80 / F83 / F85 / S73 / S77