Connections And Wiring; Power Connection; Local Area Network (Lan) Connection - Extron electronics IPL T S1 Setup Manual

Connections and Wiring

Power Connection

To connect the power supply:
1.
Insert the 2-pole captive screw connector into the power supply
receptacle on the rear panel of the controller.
Smooth
SECTION A–A
POWER
12V
.5A MAX
Figure 6.
2. Connect the female end of the AC power cord into the power
supply and the male end into a 110-220 VAC outlet.

Local Area Network (LAN) Connection

Connect a patch (straight-through) Ethernet cable to the LAN port on
the rear panel if you are connecting the controller to a switch, hub, or
router on your A/V network.
Connect a crossover Ethernet cable to the LAN receptacle on the rear
panel if you are connecting the controller directly to a PC.
MAC: 00-05-A6-XX-XX-XX
S/N:
POWER
12V
.5A MAX
14 IPL T Series • Setup
A
Ridges
A
Power Supply Output Cord
MAC: 00-05-A6-XX-XX-XX
S/N:
FLEX I/O
LAN
1 2 3 4
COM1 COM2
TX RX TX RX
Power Supply Receptacle
DC Power Cord
Captive Screw Connector
Ground
+12 VDC
AC Power Cord
Power Connector Wiring
FLEX I/O
LAN
1 2
COM1 COM2
TX RX TX RX
Local Area Network (LAN) Receptacle
3/16"
(5 mm) Max.
IR
1 2 3 4
S G S G S G S G
External
Power Supply
(12 VDC, 1 A )
IR
3 4 1 2 3 4
S G S G S G S G