Extron electronics IPL T S1 Setup Manual page 25

Then, you must change the default settings of the controller (IP
address, subnet mask, and [optional] administrator name and
password) in order to use the controller on an intranet (LAN) or
on the Internet. After you have set up the IPL T controller for
network communication, you can reset the PC to its original network
configuration.
NOTE: Both the computer and the IPL T controller must be
connected to the same subnet on a LAN (using a
straight-through cable). Alternatively, you can use a
crossover Ethernet cable to connect the controller directly
to the network adapter card of the computer.
Use ARP to configure the IP address as follows:
1. Obtain a valid IP address for the IPL T controller from the network
administrator.
2.
Obtain the MAC address of the IPL T controller from the label on
its rear panel. The MAC address should have this format:
00-05-A6-xx-xx-xx.
3.
If the IPL T controller has never been configured and is still set
for factory defaults, go to step 4. If not, perform a Mode 4 system
reset. See Resetting the Controller
CAUTION: The IPL T controller must be configured with
the factory default IP address (192.168.254.254)
before the ARP command is executed, as
described in the following steps.
4. On the PC, access the command prompt, then execute the arp -s
command. Enter the desired new IP address for the controller and
the MAC address (located on the rear panel of the controller). For
example:
arp -s 10.13.170.15 00-05-A6-00-0A-90
Figure 14.
Executing the ARP Command
for more information.
IPL T Series • Setup 19