Table of Contents
Advertisement
Reverse this procedure to install the speakers.
Vibrator module
NOTE:
The vibrator module is included in the Speaker/Vibrator Module Kit, spare part number
751307-001. This kit includes the vibrator module and cable and the left and right speakers, cables,
and grommets. The vibrator module is also included with the system board spare part kit, spare part
number 751300-001.
Before removing the vibrator module, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the back cover (see
5.
Remove the middle frame (see
6.
Remove the FPC cable (see
Remove the vibrator module:
1.
Unsolder the vibrator module cables (1) from the system board terminals.
NOTE:
to the system board "+" terminal, and the vibrator module black cable should be soldered to the
"-" terminal.
2.
Detach the vibrator module (2) from the display panel assembly. (The vibrator module is attached
to the display panel assembly with double-sided adhesive.)
3.
Remove the vibrator module.
Reverse this procedure to install the vibrator module.
22
Chapter 5 Removal and replacement procedures
Back cover on page
Middle frame on page
FPC cable on page
When installing the vibrator module, the vibrator module red cable should be soldered
12).
14).
19).
Advertisement
Table of Contents
