This chapter describes tasks to install, configure, and verify operation of the edge
switch 2/32. The switch can be installed on a table or desk top, or mounted in any
standard equipment rack.
For a list of the factory-set defaults for the switch and the Reset Configuration option,
refer to
Appendix
Summary of Installation Tasks
Table 2–1
summarizes installation tasks for the switch, HAFM server, and Ethernet
hub. The table numbers and describes each task, states if the task is required or
optional, and lists the page reference for the task. If a task is optional, decision-related
information is included.
Table 2–1: Installation Task Summary
Task Number and Description
Task 1: Verify Installation Requirements
Task 2: Unpack, Inspect, and Install the
Switch
Task 3: Configure Network Information
Task 4: LAN-Connect the Switch
Task 5: HAFM Server (Optional)
edge switch 2/32 installation guide
Installing and Configuring
B.
Required
Required
Optional—configure if connecting
multiple switches or if connecting a
switch and
LAN.
Required
Optional—if not done, then the switch
should be configured using the
Embedded Web Server (EWS)
interface.
the Edge Switch 2/32
Required or Optional
HAFM
server to a public
2
Page
2–3
2–4
2–6
2–11
2–12
2-1