Switch Setting Before Adjustment; Notes On Adjustment - Sony DXC-D30WSP Service Manual

3-1-3. Switch Setting Before Adjustment

[DXC-D30WS, DXC-D30WSP]
Switch setting for camera side
GAIN switch
OUTPUT/DL/DCC+ switch : CAM/DCC+
WHITE BAL switch
FILTER control
SHUTTER switch
ZEBRA switch
MARKER switch
HYPER GAIN switch
SET UP switch
EZ MODE switch
IRIS (Lens)
ZOOM (Lens)
[CA-537, CA-537P]
S1 switch (IF-313 board) : AUTO (Center position)
3-2
: 0 dB
: PRESET
: 1
: OFF
: OFF
: OFF
: OFF
: STD
: OFF
: Manual
: Manual

3-1-4. Notes on Adjustment

Note: (1) Before adjustment, be sure to allow for 10-
minute warm-up time.
(2) When using the SERVICE menu,
ADVANCE menu and BASIC menu, refer
to "2-7. SERVICE MODE OPERATION".
(3) Unless otherwise specified, the sentence
"chart frame = underscanned monitor
frame" is written about the shooting
condition.
In this case, make sure that the lens is best
focused.
Then adjust the zoom control of the lens so
that the chart frame touches the
underscanned monitor frame.
In case of the Grayscale chart:
(underscanned monitor screen)
DXC-D30WS/P(E)/V1