Fitting The Lens - Sony DXC-D30WSP Service Manual

Fitting the Lens

In the case of the DXC-D30F/D30PF/D30K/D30PK
model, the lens is already fitted. In other cases, use the
following procedure to fit the lens.
1
Remove the retaining rubber
which prevents the lens mount
from coming loose, then raise
the lens fixing lever, and
remove the lens mount cap.
2
With the lens fixing lever
turned fully counterclockwise,
push in the lens, aligning the
projection on the lens with the
cutout on the camera.
3
Supporting the lens, turn the
lens fixing lever fully
clockwise. Replace the
retaining rubber on the lens
mount.
26
Chapter 2 Fitting and Connections
Retaining rubber
Lens fixing lever
Lens mount cap
Align and push in.
4
Using the triangular mark as a
guide, push the lens connector
into the LENS connector on
the camera head, until it clicks
into place. Fasten the cable
with the clamps.
If using a lens with a 6-pin connector
This camera head has a 12-pin LENS connector. If the
lens cable has a 6-pin connector, fit an adaptor cable:
LO-612 (manufactured by Canon) or ECF-124
(manufactured by Fujinon) or equivalent.
LENS connector
Triangular mark
Fitting optional filters
Loosen the lens hood fixing screw to remove the lens
hood, then attach the filter.
Remove lens hood
Lens hood fixing screw
Filter (optional)
27
Chapter 2 Fitting and Connections