Warning Indications; Specifications - Sony DXC-D30WSP Service Manual

Warning Indications

If a fault occurs during operation, a warning is given
by the REC/TALLY and BATT indicators in the
viewfinder and the tally lamp lighting or flashing, and
also by warning indications on the viewfinder screen.
When you are using a DSR-1/1P or PVV-3/3P, the
Warning indications
Camera VTR
REC/ BATT Viewfinder WARNING Display Warning tone
TALLY indicator screen indicator window
indicator indication
and tally
lamp
— — RF
(during
recording
only)
(During
recording only)
— — SERVO
— — HUMID
(During
recording)
(During
playback,
rewind, or fast
forward)
— — SLACK
— — TAPE
(flashing,
(During
during
recording
recording
only)
only)
— — TAPE
(flashing)
BATT BATT
11.0V (flashing) (During
recording)
BATT BATT
10.5V (flashing)
Continuous Flashing once per second Flashing four times per second
Four beeps per second One beep per second
For the warnings appearing in the viewfinder when a VTR is connected, see the section "Viewfinder Normal Indications" (page
47).
Y/C separate signals
86
Appendix
WARNING indicator on the VTR also lights or
flashes, and warning indications appear in the display
window. There is also a warning tone in the earphone.
Fault VTR action What to do
The video The VTR emits Carry out head cleaning,
heads are a warning tone referring to the instruction
clogged, or when it detects manual for the VTR. If the
there is some head clogging. problem persists after cleaning
other fault in the heads, disconnect the
the recording power and consult your Sony
system. dealer.
The servo Recording Disconnect the power and
lock has continues, but consult your Sony dealer. (The
been lost. the recording SERVO indication may flash
may not be momentarily when the tape
satisfactory. transport starts, but this does
not indicate a problem.)
There is Recording Stop the tape transport. Wait
condensation. continues, but until the HUMID indication
if the tape does not appear when you
sticks to the power the unit on.
drum,
recording
stops.
Playback,
rewind, or fast
forward stops.
The tape is The operation Press the EJECT button to
not wound stops. (Refer eject the cassette. Close the
properly.
to the service cassette compartment and
manual or check that the top panel has
maintenance descended before powering
manual.) off. Then consult your Sony
dealer. (Do not attempt to
insert any cassette.)
The tape is Operation Change the cassette if
near the end. continues. necessary.
The tape is at Recording, Change the cassette.
the end. playback, and
fast forward all
stop.
The battery is Operation Change the battery when
almost continues. possible.
exhausted.
The battery is Operation Change the battery.
exhausted.
continues.
Continuous

Specifications

DXC-D30/D30P Camera Head
Imaging element Three-chip interline transfer CCD
768 (horizontal) × 494 (vertical)
Pixel resolution
(DXC-D30)
752 (horizontal) × 582 (vertical)
(DXC-D30P)
8.8 × 6.6 mm (corresponds to
Imaging area 2 / -
3
inch picture tube)
Built-in filter settings
1: 3200K
2: 5600K + 1 / ND
8
3: 5600K
1
4: 5600K + / ND
64
Lens mount Bayonet mount
Signal standards EIA standard signal (NTSC color
system) (DXC-D30)
CCIR standard signal (PAL color
system) (DXC-D30P)
Scanning system 525 lines, 2:1 interlace (DXC-D30)
625 lines, 2:1 interlace
(DXC-D30P)
Scanning frequencies
Horizontal:
15.734 kHz
(DXC-D30)
15.625 kHz (DXC-D30P)
Vertical: 59.94 Hz (DXC-D30)
50.00 Hz (DXC-D30P)
Synchronization Internal sync
External sync, using signal input
(VBS or BS) to the GEN LOCK
IN connector of an optional
camera adaptor or input from
the GEN LOCK connector of a
CCU-M5/M5P/M7/M7P camera
control unit to the VTR/CCU/
CMA connector of an optional
camera adaptor.
Horizontal resolution
850 TV lines (center)
Minimum illumination
0.5 lux (at f/1.4, +36 dB)
0.8 lux (at f/1.8, +36 dB)
Sensitivity 2000 lux (f/11.0 standard, 3200 K)
Gain levels Selectable –3 dB, 0 dB, 3 dB, 6 dB,
9 dB, 12 dB, 18 dB, 18 dB +
DPR, 24 dB, 24 dB + DPR, hyper
gain (30 dB + DPR)
Video output Composite signal
1.0 Vp-p, sync negative, 75 Ω,
unbalanced
Y: 1.0 Vp-p, sync negative,
unbalanced
C: burst level 0.286 Vp-p, no
sync
Video S/N ratio 63 dB (typical) (DXC-D30)
61 dB (typical) (DXC-D30P)
Registration 0.05% for all zones, without lens
Input/output connectors
VIDEO OUT connector: BNC,
75 Ω, unbalanced
LENS connector: 12-pin, for 2 / -
3
inch lens
VF connector (front): 20-pin
VF connector (left side): 8-pin
REMOTE connector 1: Stereo
mini-jack
REMOTE connector 2: 10-pin
MONITOR OUT connector: BNC,
75 Ω, unbalanced
Power supply 12 V DC
Power consumption
12 W (12.7 W when the DSR1/1P
is connected)
Operating temperature
–10 °C to +45 °C (14 °F to 113 °F)
Storage temperature
–20 °C to +60 °C (–4 °F to 140 °F)
Mass 2.3 kg approx. (5 lb 1 oz)
External dimensions in millimeters (inches)
5
242 (9 / )
8
258
(10 1 / )
4
480 (19)
VCL-916BYA Zoom Lens
Focal length 9.0 to 144 mm
Zoom Manual or power, selectable; zoom
ratio: ×16
Maximum aperture
1:1.8
Iris Manual or automatic, selectable; f/
87
Appendix